Home Books eBooks Journals References & Proceedings Authors, Editors, Reviewers A-Z Product Index Awards
Proceedings of Symposium on Energy Engineering in the 21<sup>st</sup> Century (SEE2000) Volume I-IV

ISSN:
1-56700-132-7 (Print)

INDIRECT DRYING OF THIN-FILM ALUMINA SLUDGE BY BOILING APPLICATION ON DRUM DRYING

C. Carrere-Gee
Ecole des Mines d'Albi, Centre Energétique - Environnement Route de Teillet - 81013 Albi - France

Didier Lecomte
Centre Energétique Environnement, Ecole des Mines d'Albi Carmaux, Laboratoire de Génie desProcédés des Solides Divisés, CNRS - UMR 2392, Route de Teillet, 81013 Albi CT Cedex 09 France

Olivier Fudym
Universite de Toulouse, Mines Albi, CNRS, Centre RAPSODEE, Campus Jarlard, F-81013 Albi cedex 09, France

Patricia Arlabosse
IUSTI, University of Provence, 13397 Marseille Cedex 20, France; Centre Energétique Environnement, Ecole des Mines d'Albi Carmaux, Laboratoire de Génie desProcédés des Solides Divisés, CNRS - UMR 2392, Route de Teillet, 81013 Albi CT Cedex 09 France

Bruno Ladevie
Ecole des Mines d'Albi Carmaux Centre Energetique Environnement, Campus Jarlard, 81000 Albi - France

Jean Vasseur
UMR Génie Industriel Alimentaire AgroParisTech-Cemagref-INRA, AgroParisTech 16, rue Claude Bernard, 75231 Paris cedex 05, France

Abstract

This work presents a simple method developed for the design of indirect dryers in thin-film by boiling for an alumina sludge treatment. The method developed is based on decoupling of the internal and external transfers. In a first step, external transfers are characterized. A simple experimental device was built up in order both to provide and to estimate the heat flux density at the interface between a hot metallic plate and the drying sample. An analytical direct model is made using the quadripole formalism, and the system transfer function is calculated. The inverse problem is solved using the Beck's sequential function specification method, and the corresponding drying curve is deduced by an energy balance without weighing.
In the second part, the drying of sludge on an electrically heated laboratory drum dryer was studied. The aptitude of sludge to be coated on the cylinder is related to thermal effects. The drying kinetics are obtained by sampling and are compared with those obtained with the first experimental device. The curves are similars whereas the drying time is much longer. A simple model of the drum dryer is developed by taking into account the combined effects of the internal and external transfers. In this case, the importance of the internal transfers, which govern the drying time, are highlighted.