Atomization and Sprays Journal of the International Institutes for Liquid Atomization and Spray Systems

ISSN for PRINT: 1045-5110

For Online Access

Best Paper Award Selection - Editorial Board Site

2005, Volume15

Issue 2

134 pages

DOI: 10.1615/AtomizSpr.v15.i2

Issue price - $92.00

Marc Lorcher
Bayer AG, BTS-ENG-CP-ACSC, Rheinufer 7-9, R85, 47829 Krefeld, Germany

Florian Schmidt
University of Hannover, Institut fur Verfahrenstechnik (Process Engineering), Callinstr. 36, 30167 Hannover, Germany

Dieter Mewes
University of Hannover, Institut fur Verfahrenstechnik (Process Engineering), Callinstr. 36, 30167 Hannover, Germany

Liquids or suspensions are dispersed into sprays of small droplets by atomization of two-phase gas-liquid mixtures. Thus narrow droplet diameter distributions and a high interface area density of the liquid phase are generated in order to increase heat and mass transfer. The mean droplet diameter of the spray is time dependent. It also depends on the total pressure upstream from the nozzle, the volumetric flow rates of the liquid and the gas phase, as well as on the flow regime inside the nozzle. The radial and axial profiles of the void fraction inside the nozzle are measured with an electrical measurement technique. In addition, the flow in the nozzle is visualized by a high-speed camera. Three flow regimes are identified. A model is established to predict the flow regime inside the atomizer. It turns out that the flow regime changes by accelerating the flow to critical conditions. The visualized flow fields are compared to calculated ones. A model to predict the breakup regime is established considering the phase distribution and the critical flow conditions at the exit cross section.

DOI: 10.1615/AtomizSpr.v15.i2.30 Download article, 145-168 pages

Article price - $35.00

<< Previous article   Next article >>