Heat and Mass Transfer Australasia

ISBN Print: 978-1-56700-099-3

A TECHNIQUE FOR MEASURING PRODUCT HEAT LOAD DURING BEEF CHILLING

Purchase PDF Purchase PDF $35.00

DOI: 10.1615/978-1-56700-099-3.530
pages 453-460

Lucy Davey School of Chemical Engineering and Industrial Chemistry University of New South Wales, Sydney 2052, Australia

Q. Tuan Pham School of Chemical Engineering and Industrial Chemistry University of New South Wales, Sydney 2052, Australia

Abstract

The refrigeration of beef carcasses is an important user of energy. Due to the carcass's complicated shape and composition, it is difficult to calculate the rate of heat release as it evolves with time during the cooling process. A method has therefore been devised to measure the latent, sensible and radiative heat loads from beef sides. The latent heat load is measured within 3% error by suspending the beef side on a load cell measuring to ± 0.15 ppm. The sensible and radiative heat load is measured within 5% error using a flow-calorimeter type movable wind tunnel constructed to hold one beef side. Due to the small magnitudes of the weight losses, relatively large fluctuations in the weight loss curve occurred and it was necessary to smooth the curve by curve-fitting a three-parameter equation, using an evolutionary algorithm. Typical results are shown. These results are much more precise than results obtained earlier with compensatory heating methods.

Begell Recommend

Electrospinning of Micro- and Nanofibers: Fundamentals in Separation and Filtration Processes Electrospinning of Micro- and Nanofibers: Fundamentals in Separation and Filtration Processes Y. Filatov
A. Budyka
V. Kirichenko ISBN Print: 978-1-56700-241-6
ISBN Online: 978-1-56700-240-9
 Thermal Radiation in Disperse Systems: An Engineering Approach Thermal Radiation in Disperse Systems: An Engineering Approach Leonid A. Dombrovsky
Dominique Baillis ISBN Print: 978-1-56700-268-3
ISBN Online: 978-1-56700-351-2