Inicio Libros eLibros Revistas Referencias y Libros de Ponencias Autores, Editores, Críticos Índice de Productos de la A a la Z Premios
Progress in Plasma Processing of Materials, 1999

1-56700-126-2 (Imprimir)


S. Janisson
CEA/DAM Le Ripault, BP 16 - 37260 Monts - France

Armelle Vardelle
ENSIL, ESTER Technopole, 87068 Limoges - France

Michel Vardelle
LMCTS-URA 320, University of Limoges, 123 Avenue Albert Thomas -87060 Limoges Cedex - France

Pierre Fauchais
Laboratoire Sciences des Procedes Ceramiques et de Traitements de Surface UMR CNRS 6638 University of Limoges 123 avenue Albert Thomas, 87060 LIMOGES - France

Erick Meillot
CEA/DAM Le Ripault, BP 16 - 37260 Monts - France


Materials which exhibit high specific heat and melting enthalpy combined with a low density, like boron carbide B4C, are difficult to melt by plasma spraying under standard spray conditions. Moreover, the injection of this low-density powder in the plasma jet is critical, specially when fine particles are used. The optimization of the plasma-forming gas composition may make the penetration of the particles in the gas flow easier, and improve their melting state.
This paper presents an investigation of the effect of the composition of ternary gas mixtures of argon, helium and hydrogen on B4C particles heating and acceleration.
The particle injection and the resulting spray pattern in the jet were controlled by using a 1−D imaging technique. The particle velocity distribution was measured with a laser Doppler anemometer and the particle overall temperature with a high-speed pyrometer.